ISCAR INDUSTREALIZE - Railway - Locomotive / Car wheels - Axle Shaft - Finish Turning

Option 1- Turning Finishing ISOTURN Based on accumulated experience with our current ISO TURN line, ISCAR has started the process of designing new chipformers which, together with the most advanced SUMOTEC grades, provide higher productivity, tool life and performance reliability. The new inserts already carry more systematic designations in order to facilitate insert selection by the end-user. The F3P chipbreaker has positive rake angles for smooth cutting, reduced cutting forces and insert wear, leading to dramatically increased tool life. The machining application area is 0.40 - 2.0 mm D.O.C. and 0.05 - 0.25 mm/rev feed. Features * Double-sided insert with chipbreaker for finishing steel * Reinforced cutting edge * Positive rake angle for smooth cutting and low forces Option 2 - Turning Finishing SUMO-CHAM WG chipformer shorten finishing time by using higher feeds while giving the same or better performance. In many cases this chipbreaker can eliminate grinding Polished rake to N2 class (Ra = 0.07 µm) for better chip flow. WF chipbreaker designed for super-finishing on soft and gummy materials. * Sharp cutting edges to reduce cutting forces. * Back turning enabled for reducing cycle time. * Small corner radius of 0.05 mm. A wiper geometry for machining at high feed, leaving high surface finish. Left- and right-hand inserts. Option 3 -Turning Finishing SUMO-CHAM WNGA inserts with High speed, roughing and finish machining of typical automotive parts Higher cutting speeds, when compared to SiN based ceramic grades. Can be used for both wet and dry machining For more information: https://www.iscar.com/newarticles.aspx/countryid/1/newarticleid/1888 https://www.iscar.com/newarticles.aspx/countryid/1/newarticleid/179 #ISCAR, #INDUSTREALIZE, #Railway, #Locomotive, #Carwheels, #AxleShaft, #FinishTurning, #ISOTURN, #SUMO-CHAM